Rear Tine TillerModel RB-530PRINTED IN U.S.A.OPERATOR’S MANUALIMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYWHITE OUTDOOR PRODUCTS COMPANY P.
10SECTION 5: ADJUSTING YOUR TILLERHandle AdjustmentThe handle height may be adjusted. Refer to the Know Your Tiller Section.Belt Tension AdjustmentPe
11Belt Replacement• Disconnect and ground the spark plug wire against the engine.• Remove two torx head screws from the top of belt cover.• Remove two
12SECTION 7: TROUBLESHOOTINGNOTE: For repairs beyond the minor adjustment listed above, contact your nearest authorized service dealer.Trouble Possib
14Model RB-530
15Model RB-530Ref. No.Part No. Part Description1. 735-0246 Vinyl End Plug2. 647-0014 Clutch Control Ass’y.3. 710-1017 Torx Mach Screw 1/4 x .62"4
16Model RB-530Ref. No.Part No. Part Description1. 710-3008 Hex Bolt 5/16-18 x .75" Lg.2. 712-3004A Hex Top L-Nut 5/16-18 Thd.3. 786-0107 Cable Mt
17Model RB-530Ref. No.Part No. Part Description1. 721-0295 Chain Case Gasket2. 786-0086 Reinforcement Plate3. 716-0865 Snap Ring4. 750-0938 Spacer .73
2TABLE OF CONTENTSContent PageImportant Safe Operation Practices...3Assembling Your Ti
MANUFACTURER’S LIMITED WARRANTY FOR:The limited warranty set forth below is given by White Out-door Products Co. with respect to new merchandise pur-c
3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: This symbol points out important safety instructions which, if not followed, could endanger th
44. Keep bystanders, helpers, pets, and children at least 75 feet from the machine while it is in operation. Stop the machine if anyone enters the are
5SECTION 2: ASSEMBLING YOUR TILLERIMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline a
6Figure 3• Place the hex opening of the hex nut retainer bracket over the flange nut securing the handle adjustment lock and install the lock nut on t
7Figure 8NOTE: Do not overtighten control wire. Too muchtension may cause it to break.Final Clutch Adjustment• Position the tiller so the front count
8Read this operator’s manual and guidelines before operating your tiller. Compare the illustrations in this manual with your unit to familiarize yours
9engine falters, return to choke position and then slowly move to RUN position.• Refer to engine manual for additional engine information.Stopping Eng
Comments to this Manuals