White Outdoor Series 79G Operator's Manual download pdf (Page 22)

Side to Side

If the cutting deck appears to be mowing unevenly, a side to side

adjustment can be performed. Adjust if necessary as follows:

With the tractor parked on a firm, level surface, place the 1.

deck lift lever in the top notch (highest position) and rotate

both blades so that they are perpendicular with the tractor.

Measure the distance from the outside of the left blade 2.

tip to the ground and the distance from the outside of the

right blade tip to the ground. Both measurements taken

should be equal. If they’re not, proceed to the next step.

Loosen, but do NOT remove, the hex cap screw on the left 3.

deck hanger bracket. See Fig. 6-6.

Balance the deck by using a wrench to turn the adjustment 4.

gear (found immediately behind the hex cap screw just

loosened) clockwise/up or counterclockwise/down.

The deck is properly balanced when both blade tip

measurements taken earlier are equal.

Retighten the hex cap screw on the left deck hanger 5.

bracket when proper adjustment is achieved.

Seat Adjustment

Refer to the Set-Up and Assembly section of this manual for seat

adjustment instructions.

Parking Brake Adjustment

8"3/*/(Never attempt to adjust the brakes

while the engine is running. Always disengage PTO,

move shift lever into neutral position, stop engine

and remove key to prevent unintended starting.

If the tractor does not come to a complete stop when the brake

pedal is completely depressed, or if the tractor’s rear wheels

can roll with the parking brake applied, the brake is in need

of adjustment. See an authorized Service Dealer to have your

brakes properly adjusted.

'JHVSF

)FY$BQ4DSFX

 SECTION 6— MAINTENANCE & ADJUSTMENTS

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

No comments

White Outdoor Series 79G Operator's Manual Page 22