White-outdoor SB1350W User Manual download pdf (Page 14)

• Reassemble new slide shoes with the hardware

removed earlier (cupped side of belleville washer

against the slide shoes). Make certain the slide

shoes are adjusted to be level.

• To remove the shave plate, remove slide shoe as

well as the carriage bolts, belleville washers and

hex nuts which attach shave plate to the snow

thrower housing. For location of shave plate and

carriage bolts, see Figure 15.

• Reassemble the new shave plate, making sure

heads of carriage bolts are to the inside of the

housing.

• Reinstall the skid shoes and tighten securely.

Replacing Belts

To remove and replace either the auger belt or the drive

belt, follow the steps below and then proceed to the

specific steps listed under respective sub-headings.

• Disconnect the chute crank assembly at the

discharge chute end by removing the hairpin clip

and the two flat washers.

Figure 16

• Remove the plastic belt cover, located near the

engine, by removing the three self-tapping screws

and flat washers that secure it. See Figure 16.

• Remove the large shoulder bolt and washer on the

left hand side of the engine pulley. See Figure 16.

Auger Belt

• Remove the cotter pin and washer from the ferrule

in order to disconnect the auger idler rod from the

brake bracket assembly. See Figure 17.

• Slip the auger control belt (the front belt) off the

engine pulley.

Figure 17

• Pull the brake bracket assembly towards the cable

guide roller and unhook the auger cable “Z” fitting.

• Remove the upper bolts and lock washers which

attach the auger housing assembly to the frame

assembly using a 9/16” wrench. See Figure 16.

• Separate the auger housing from the frame

assembly by tilting the housing forward and pulling

up the handles.

• Using a 1/2” wrench, remove the hex screw and

belleville washer from the center of the pulley on

the auger housing. Lift the brake bracket assembly

out of the pulley groove and remove the pulley. Be

careful not to lose the key. See Figure 18.

Figure 18

Upper Bolt

(remove)

Hairpin

Clip

Flat

Belt Cover

Belt Cover Bolts(3)

Shoulder Bolt

(do not remove)

Washers

Shoulder Bolt

Engine Pulley

Ferrule

Engine

Pulley

Auger Idler

Rod

Auger Control

Belt

Brake Bracket

Assembly

Z Fitting

Cable Roller

Guide

Brake Bracket Assembly

Auger Belt

Hex Screw

Belleville Washer

Belt Keepers

Auger Pulley

Idler Pulley

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments

White-outdoor SB1350W User Manual Page 14

Comments to this Manuals

Related products and manuals for Cars White-outdoor SB1350W