White-outdoor Yard Boss 950 User Manual download pdf (Page 6)

Attaching The Front Wheels

• Tilt the unit backward, so that it rests on the handle

(place a piece of cardboard under handle to avoid

scratches). Remove the packing material around

the wheel brackets.

• Remove the hex lock nuts and shoulder bolts from

the ends of the wheel bracket. See Figure 2.

• Place a wave washer on each shoulder bolt and

insert bolt through each wheel with the flat side of

wheel facing out.

• Place the cupped washer on shoulder bolt with the

crowned side against the wheel.

• Assemble each wheel to outside of wheel bracket

and secure with hex lock nut previously removed.

• Attach hub caps to wheels by placing hub cap

against the inner hub of wheel. Press firmly around

the center portion of hub cap in a circular motion.

The hub caps are flexible and it will snap over the

wheel hubs.

Figure 2

Attaching The Nozzle

• Remove three wing nuts from the front of the

chipper shredder vacuum.

• Place nozzle in position over the three studs on unit

and secure with wing nuts just removed.

See Figure 3.

Figure 3

NOTE: The metal tab on the nozzle must depress the

safety switch button attached to the front of chipper

shredder vacuum or the engine will not start.

See Figure 3

• Set unit in the upright position.

Attaching The Chipper Chute

• Remove the two hex bolts, flat washers, and hex

nuts that are attached to the support bracket.

• Attach the support bracket under the chipper chute

loosely using the hardware previously removed.

The hex bolts and washers should be inserted from

the inside of the chipper chute. See Figure 4.

Figure 4

• Remove the two hex lock nuts from the hex bolts

that secure the right side of the upper handle to the

lower handle. Leave the bolts and washers in

place. See Figure 4.

• Remove three cupped washers and hex nuts from

the weld studs besides the opening on the right

side of the chipper shredder vacuum.

• Place the chipper chute over the weld studs with

the slot at the bottom. Secure with cupped washers

(cupped side of washer goes against the chipper

chute) and hex nuts just removed and only tighten

the nuts slightly for ease of further assembly.

• Place the support bracket through the two bolts in

the handle. Lifting up on the chipper chute will aid in

the alignment of the holes in the support bracket

with the bolts in the handle.

• Tighten all hardware securely on the chipper chute,

support bracket, and handle.

Attaching The Clutch Cable To Handle

• Loosen the hex nuts at the cable bracket and back

the bottom hex nut all the way down.

• While holding the drive clutch handle up, hook the

“Z” end of the cable into the drive clutch handle

from the outside. See Figure 5.

Hex Lock

Nut

Cupped

Washer

Wave

Washer

Hub Cap

Shoulder

Bolt

Wing

Nuts

Wing

Nut

Nozzle

Safety

Switch

Chipper Chute

Upper

Handle

Lower

Handle

Support

Bracket

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

White-outdoor Yard Boss 950 User Manual Page 6

Comments to this Manuals

Related products and manuals for Gardening equipment White-outdoor Yard Boss 950