White-outdoor Yard Boss 950 User Manual download pdf (Page 9)

• Engines with choke lever:

Move choke lever on engine to CHOKE position. (A

warm engine may not require choking).

• Engines with primer:

Prime engine as instructed in separate engine

manual.

• The throttle control lever is located on the engine.

Move engine throttle control lever to FAST or

START position.

• Place one foot on the left rear wheel to prevent the

unit from skidding while starting.

• Grasp starter handle and pull rope out slowly until

engine reaches start of compression cycle (rope

will pull slightly harder at this point).

• Pull rope with a rapid, continuous, full arm stroke.

Keep a firm grip on starter handle. Let rope rewind

slowly.

• Repeat the previous steps until engine fires. When

engine starts, move choke control (if equipped)

gradually to RUN position.

WARNING: Keep bystanders, helpers,

pets, and children at least 75 feet from the

machine before starting and while

operating. Do not operate this machine

unless the discharge chute and bag have

been properly installed and secured to the

machine.

To Empty Bag

The bag is designed to be emptied without being

removed from unit. Open the large zipper in the rear of

the bag to empty the contents. If bag is removed for any

reason, follow the instructions for attaching the bag in

the ASSEMBLY section. Be certain the zipper is closed

completely when operating the unit.

To Engage Drive

IMPORTANT:

Always release the drive clutch handle

before moving the shift lever.

With the engine running at top speed and drive clutch

handle disengaged, move shift lever into one of the six

FORWARD positions or two REVERSE positions.

Select a speed appropriate for the conditions that exist.

Use the slower speeds until you are familiar with the

operation of the chipper shredder vacuum.

To engage the wheel drive, hold the drive clutch handle

against the upper handle. Releasing the drive clutch

handle stops the wheels from driving. Release the drive

clutch handle to slow down when negotiating an

obstacle, making a turn, or stopping. Engage handle

slowly to prevent the front wheels from lifting up.

Using the Chipper Shredder Vacuum

Place both hands on top of upper handle to push unit

over yard waste. Yard waste such as leaves and pine

needles can be vacuumed up through the nozzle for

shredding. After material has been shredded by the

blades on the impeller assembly, it will be discharged

into catcher bag. Do not attempt to shred or chip any

material other than vegetation found in a normal yard

(i.e. branches, leaves, twigs, etc.) Avoid fibrous plants

such as tomato vines until they are thoroughly dried

out. Materials such as stalks or heavy branches up to 3”

in diameter may be fed into the chipper chute. See

Figure 9.

WARNING: Do not attempt to shred, chip,

or vacuum any material larger than

specified on the machine or in this

manual. Personal injury or damage to the

machine could result.

Figure 9

IMPORTANT:

The flail screen is located inside the

housing in the discharge area. If the flail screen

becomes clogged, remove and clean as instructed in

MAINTAINING YOUR CHIPPER SHREDDER

VACUUM. For best performance, it is also important to

keep the chipper blade sharp.

Tire Pressure (Pneumatic Tires Only)

WARNING: Maximum tire pressure under

any circumstance is 30 psi. Equal tire

pressure should be maintained at all

times.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

White-outdoor Yard Boss 950 User Manual Page 9

Comments to this Manuals

Related products and manuals for Gardening equipment White-outdoor Yard Boss 950