White Outdoor LT-1850 Operator's Manual Page 71

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 70
OperatingtheTractor
Snowt hrowe r
& Dozer
Applications
_k_;_ _L_.i ;'" _ .-I_-=_.-'" Mower
_-. _._-5: .? .-;.-_ _ Applications
Figure 17. Lift Lock Plate - Hydraulic Lift Models
A. Lift Cylinder
B. Flat Head Pin (Original)
C. Flat Head Pin (New)
D. Lock Plate
E. Hair Pin Clips
F. Lift Shaft Assy.
G. Washers
LIFT VARIATIONS WHEN USING
ATTACHMENTS
When a front-mounted attachment such as a snowthrow-
er or dozer blade is used with the tractor, the lift mecha-
nism must be locked to provide downward force. When
the mower is reinstalled the downward pressure lock
must be released so that the mower can float.
Hydraulic Lift Models
Fully lower the hydraulic lift. The lift assembly is spring
loaded so it will need to be held in the down position to
perform of the following procedures.
When using a snowthrower or dozer, the downward
pressure lock plate (D, Figure 17) and an additional pin
(C) is installed. These parts are included with the attach-
ment. Note that the washers (G) are not used with the
lock plate.
When mowing, the downward pressure lock plate (D) is
removed and replaced with two washers (G). The addi-
tional pin (C) is also removed.
Snowthrower
& Dozer (__.._
Applications
Mower
Applications
Figure 18. Lift Link - Manual Lift Models
A. Pin
B. Rear Hole of Lift Bar (Snowthrower Applications)
C. Spacer
D. Hair Pin Clip
E. Upper Hole (Snowthrower Applications)
F. Slot of Lift Link (Mower Applications)
G. Lower Hole (Mower Applications)
Manual Lift Models
NOTE: These instructions apply to Conquest / 1700 /
2700 / YT Series tractors or Broadmoor /1600 / 2600
Series tractors equipped with a rift lever kit.
The lift link is installed differently depending on what
attachment is being used. Refer to Figure 18 for link
installation information.
20
Page view 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 99 100

Comments to this Manuals

No comments